DRIVE BY WIRE SHOULD NOT BE USED ON PUBLIC HIGHWAYS. INCORRECT USAGE CAN CAUSE DEATH OR INJURY AND IS ENTIRELY USED AT THE END USERS OWN RISK.


Drive by Wire (DBW) allows a host of other features. You can access it from the DBW section of the Entity true, and follow this simple setup guide. OEM installations that use DBW with a our Plug-In solutions already have the majority of their settings pre-configured. Note that when using DBW you can omit the fitting of a PWM/Stepper based Idle Valve as the DBW system can also be set to manage idle control.


The process for configuring Drive-By-Wire is as follows:


  1. Install physical wiring as per the wiring guide for DBW here.
  2. Configure and calibrate the Pedal Position Sensors and Throttle Position Sensors
  3. Test the Throttle in Manual Mode.
  4. Calibrate the PID controller to give fast response with low overshoot.
  5. Start the engine in "Manual Percent" mode to find the idle values and configure the idle control.